Board comparison

Pick two boards: chip, memory, radio, pins, USB, power and size line up side by side, differences highlighted.

Often compared

Where the numbers in the table come from

GPIO, ADC, DAC, Touch, USB connector, power inputs and size are counted from the pinouts of the boards in the catalog. Free GPIOs are those without flash, PSRAM and lines used inside the board: on an ESP32 DevKit the flash pins GPIO6-11 are not counted.

Cores, clock speed, RAM, Wi-Fi and Bluetooth come from the datasheets of the chips and radio modules, and the source is named under the table. If a board runs below the chip's maximum frequency, like the 3.3 V Arduino Pro Mini at 8 MHz, the table shows the board's frequency.

Examples

  • ESP32 DevKitC V4 and ESP32-C3 SuperMini: the first has 2 Xtensa LX6 cores, 26 free GPIOs, 2 DAC outputs and 10 Touch pins; the second has 1 RISC-V core up to 160 MHz, 13 GPIOs and USB-C on an 18 × 22.52 mm board.
  • Arduino Uno R3 and Nano V3: one chip, an ATmega328P at 16 MHz. They differ in the USB connector (USB-B and mini-USB), the size and the number of pins.

FAQ

How is the ESP32 different from the ESP32-C3?
The ESP32 has two Xtensa LX6 cores up to 240 MHz, Bluetooth 4.2 with Classic mode, a DAC and Touch. The ESP32-C3 has one RISC-V core up to 160 MHz and Bluetooth 5 LE without Classic mode, and no DAC or Touch. The USB Serial/JTAG port is built into the C3 itself.

You might also need