Breadboard layout

Where to put boards and modules on a solderless breadboard and which wires to add so you get the diagram from the builder.

Laying the diagram out…

How a breadboard is built

An 830-point breadboard has 63 columns. In each column five holes a-e are connected, and separately five holes f-j; between the groups of five there is a 7.62 mm (0.3 inch) channel, and they are not connected across it. Along the long edges run two rails each, plus and minus, of 50 holes: 630 holes in the columns and 200 in the rails make 830.

The page takes a circuit from the builder by link or from the draft and lays it out: a board with two rows of pins goes across the channel, single-row modules into row e or f, ground and power are brought to the rails, and the remaining nets are joined with jumpers. Then the breadboard's nets are checked against the circuit. The rails in the layout are treated as continuous, and the top and bottom pairs are joined with a jumper.

Examples

  • The 38-pin ESP32 DevKitC has rows 25.4 mm apart, so on one breadboard no free holes are left outside it. The layout puts two breadboards together along their long sides, and the board sits across the seam.
  • An nRF24L01 with a 2×4 header doesn't fit in a breadboard: both rows would land in the same columns and short. The page puts the module beside the breadboard, and female-to-male wires run to the breadboard.

Common mistakes

  • People put a chip or a button on one half of the breadboard. The opposite pins end up in the same column and are shorted, so they must straddle the channel.
  • People feed power to the top rail and expect it on the bottom one. The top and bottom rails are not connected to each other, you need a jumper.
  • People miss a break in the rail in the middle. The board on the right has no power, even though the rail on the left is live.

FAQ

Which holes on a breadboard are connected?
In each column five holes a-e are connected, and separately five holes f-j. The plus rail and the minus rail are connected along the breadboard, and the top and bottom pairs are not connected to each other.
Is there a break in the rail in the middle?
On some breadboards the rails are split into two halves, and the red and blue line doesn't always show the break. Check the rail with a multimeter's continuity mode. The layout on the page treats the rails as continuous: on a breadboard with a break, put a jumper across the middle of each rail.
How do I move a circuit from the builder to a breadboard?
In the builder click "On a breadboard": the page opens in a new tab with the circuit in the address. It shows the layout picture and the steps: what to insert where and which wires to add.

You might also need