Wiring diagram builder

Drag boards onto the canvas and connect the pins with wires. The site tells you where 5 V, power or a bus is wired wrong.

Loading the builder…

What the builder checks

Boards and modules come from the pinout catalog and are joined with wires, pin to pin. The builder groups the wires into nets and checks each one: power shorted to ground, 5 V on a pin with 3.3 V logic, current drawn from the board's power pin, heating of the linear regulator, a module without ground or without power, a wire to a flash pin or a strapping pin, an LED without a resistor, and a motor on a pin without a driver.

Buses have their own rules: SDA to SDA and SCL to SCL, TX of one board to RX of the other, matching SPI lines and separate CS pins, pull-ups and duplicate addresses on I2C. "Error" is shown where the circuit will burn out, short or not work, "check" where the result depends on something you can't see in the schematic. The 5 V check skips a wire marked "through a divider or level shifter".

Examples

  • The HC-SR04 runs on 5 V and its ECHO outputs 5 V. A wire from ECHO to an ESP32 GPIO gets an error with advice to add a 1 kΩ and 2 kΩ divider, and after you mark it "through a divider" the error clears.
  • Two SSD1306 OLEDs on one bus both answer at 0x3C by default. The builder reports an error and advises moving the address resistor on the back of one module, so that it answers at 0x3D.

FAQ

How is the builder different from Fritzing and Tinkercad?
The builder runs in the browser with nothing to install and no account, the circuit is stored in the link and in a file, the image is saved as PNG and SVG, and the connections can be exported for KiCad and EasyEDA. It has no code simulator: the check works from wires, voltages and currents in the board database. Fritzing is installed on a computer, and the ready-made build on fritzing.org costs 8 euros. Tinkercad Circuits runs in the browser with an Autodesk account and runs Arduino code in a simulator.
How do I connect a 1602 display to an Arduino over I2C?
GND to GND, VCC to 5V, SDA to A4 and SCL to A5 on the Uno and Nano. An adapter with a PCF8574T answers at 0x27, with a PCF8574AT at 0x3F, and the 4.7 kΩ pull-ups are already on the adapter. If the screen lights up but shows no characters, adjust the contrast with the potentiometer on the adapter.
Can I power 5 V modules from an ESP32?
The 3V3 pin doesn't give a 5 V module enough voltage; such modules are powered from the 5V or VIN pin, which carries the USB voltage. A signal from a module with 5 V logic goes to a GPIO through a divider or a level shifter. On an LCD1602 adapter the SDA and SCL lines are pulled up to its own supply, so with 5 V power the ESP32 pins would get 5 V.
How do I save a circuit and send a link?
The "Link to the circuit" button packs the circuit into the address after #s=. The browser doesn't send that part of the address to the server, so the site doesn't store the circuit. The ".olerast.json file" button saves a file, and "Open file" opens it again. A draft stays in the browser until you clear the field.

You might also need