Power supply for an LED strip

Pick a strip or enter your own power per metre. The calculator sizes the supply with a margin, gives the current and checks the wire to the strip.

Power supply at least

W87 W

Strip power
72 W
Strip current
6 A
Supply with 20 % margin
86.4 W, 7.2 A
Current in the wires
6 A
  • The wire loses 0.56 V (4.7 %), only 11.44 V reaches the strip. For losses under 3 % use wire of 1.5 mm² or thicker.

Take the power per metre from the reel or the strip description. For WS2812B, 18 W/m means white at full brightness, and colour effects draw less.

How to size a power supply for a strip

The strip's power is its power per meter multiplied by its length. The current is the power divided by the strip's voltage. Take the supply with a 20-30 % margin: at its limit it runs hotter.

The wire from the supply to the strip counts as two conductors (plus and minus) with the copper resistivity of 0.0175 Ω·mm²/m. The voltage drop equals the current multiplied by the wire resistance. The calculator treats a loss of up to 3 % as acceptable and picks a wire gauge if the loss is larger. With power fed from both ends, two pairs of wires go to the strip, and each carries half the current.

The wire's allowable current is taken from table 1.3.4 of the PUE (the Russian electrical installation code) for copper wires laid in the open: 0.5 mm² 11 A, 0.75 mm² 15 A, 1.5 mm² 23 A.

Examples

  • 5 m of 5050 strip with 60 LEDs per meter, 12 V, 14.4 W/m: 72 W and 6 A. With a 20 % margin the supply is at least 87 W, and in practice 100 W. A 0.75 mm² wire 2 m long loses 0.56 V (4.7 %), and for 3 % you need 1.5 mm².
  • 1 m of WS2812B with 60 LEDs: 18 W and 3.6 A at 5 V with full-brightness white. A 5 V supply of at least 22 W with a 20 % margin, in practice 5 V 4-5 A.

Common mistakes

  • People connect three 5 m reels in series and power them from one end. The traces of the first reel carry the current of all three and heat up, and the far end glows dimmer. Power each reel with its own wires from the supply.
  • People take a supply with the same power as the strip. The supply runs at its limit and gets hot.

FAQ

What power supply do I need for 5 meters of 12 V LED strip?
It depends on the strip: a 3528 strip with 60 LEDs per meter at 4.8 W/m gives 24 W and needs a supply of at least 29 W, a 5050 strip with 60 LEDs per meter at 14.4 W/m gives 72 W and needs at least 87 W. The power per meter is printed on the reel.
What wire gauge for an LED strip?
It depends on current and length: at 6 A with a 2 m wire to the strip, 0.75 mm² loses about 0.56 V, which for 12 V is 4.7 %. The calculator picks a gauge for a loss of up to 3 % on its own.
How much current does a WS2812B draw?
Up to 60 mA per LED at full-brightness white, which is 3.6 A per meter of a 60-LED strip. Color effects at medium brightness draw several times less. You can limit brightness in code, for example with FastLED.setMaxPowerInVoltsAndMilliamps.

You might also need