Connect the board and press Flash. Then go back to the tester and connect it again. Back to the tester
Connect the board
With a USB cable to this computer. The browser asks which port to open.
Pico, Digispark and nRF52 connect without a port:
Firmware selected
olerast tester 1.0
397 KB
Flash
The browser asks for the port if the board is not connected yet.
Settings
How it works and FAQ
The page flashes olerast tester from a file hosted on the site. The flasher identifies the board by the bootloader's reply and picks the right build for it by itself, and the file is checked against its SHA-256 before writing. For ESP the file is written at 0x0, for Arduino it is a .hex sent through the board's bootloader.
FAQ
Which boards have tester firmware?
ESP32 (DevKitC, DOIT), ESP32-C3, ESP32-S3, ESP32-C5, ESP8266 (NodeMCU, Wemos D1 mini), Arduino Uno and Nano, including a Nano with the old bootloader.
What do I do after flashing?
Close the serial monitor if you had it open, go back to the "Board tester" page and click "Connect". While the port is open in another tab, the tester can't connect to it.
How do I get my own firmware back?
Flash your sketch from the Arduino IDE, or flash a file with the flasher: the tester is erased when you write. The Arduino bootloader and the ESP's ROM bootloader stay in place. When the Arduino IDE uploads to an ESP32, it writes the bootloader, partition table and application again.