ESP32 DevKit V1 (30 pin) vs ESP8266 NodeMCU V3 LoLin

11 of 16 rows differ and are highlighted. Both pinouts are below the table.

WhatESP32 DevKit V1 (30 pin)ESP8266 NodeMCU V3 LoLin
ChipESP32 (ESP32-D0WDQ6 / D0WD-V3)ESP8266EX
Cores2 × Xtensa LX61 × Tensilica L106
Clockup to 240 MHzup to 160 MHz
RAM520 KBabout 50 KB free with Wi-Fi
Flashnot statednot stated
Wi-FiWi-Fi 4, 2.4 GHzWi-Fi 4, 2.4 GHz
BluetoothBluetooth 4.2 and BLEnone
GPIO25 free11 free
ADC15 inputs1 input
DAC2 outputsnone
Touch9 pinsnone
USBmicro-USBmicro-USB
PowerMicro-USB, VIN, 3V3Micro-USB, VIN, VU
Batterynonenone
Size28.2 × 51.8 mm31 × 58 mm
Logic3.3 V3.3 V

GPIO, ADC, DAC, touch, USB and power are counted from the board pinouts, without pins taken by flash and PSRAM. Cores, clock, RAM and radio: Espressif, ESP32 Series Datasheet; Espressif, ESP8266EX Datasheet.

Compare ESP32 DevKit V1 (30 pin) with another board

Where the numbers in the table come from

GPIO, ADC, DAC, Touch, USB connector, power inputs and size are counted from the pinouts of the boards in the catalog. Free GPIOs are those without flash, PSRAM and lines used inside the board: on an ESP32 DevKit the flash pins GPIO6-11 are not counted.

Cores, clock speed, RAM, Wi-Fi and Bluetooth come from the datasheets of the chips and radio modules, and the source is named under the table. If a board runs below the chip's maximum frequency, like the 3.3 V Arduino Pro Mini at 8 MHz, the table shows the board's frequency.

Examples

  • ESP32 DevKitC V4 and ESP32-C3 SuperMini: the first has 2 Xtensa LX6 cores, 26 free GPIOs, 2 DAC outputs and 10 Touch pins; the second has 1 RISC-V core up to 160 MHz, 13 GPIOs and USB-C on an 18 × 22.52 mm board.
  • Arduino Uno R3 and Nano V3: one chip, an ATmega328P at 16 MHz. They differ in the USB connector (USB-B and mini-USB), the size and the number of pins.

FAQ

How is the ESP32 different from the ESP32-C3?
The ESP32 has two Xtensa LX6 cores up to 240 MHz, Bluetooth 4.2 with Classic mode, a DAC and Touch. The ESP32-C3 has one RISC-V core up to 160 MHz and Bluetooth 5 LE without Classic mode, and no DAC or Touch. The USB Serial/JTAG port is built into the C3 itself.

You might also need