Raspberry Pi Pico W vs ESP32 DevKit V1 (30 pin)

11 of 16 rows differ and are highlighted. Both pinouts are below the table.

WhatRaspberry Pi Pico WESP32 DevKit V1 (30 pin)
ChipRP2040ESP32 (ESP32-D0WDQ6 / D0WD-V3)
Cores2 × Cortex-M0+2 × Xtensa LX6
Clockup to 133 MHzup to 240 MHz
RAM264 KB520 KB
Flashnot statednot stated
Wi-FiWi-Fi 4, 2.4 GHzWi-Fi 4, 2.4 GHz
BluetoothBluetooth 5.2Bluetooth 4.2 and BLE
GPIO26 free25 free
ADC3 inputs15 inputs
DACnone2 outputs
Touchnone9 pins
USBmicro-USBmicro-USB
PowerMicro-USB, VSYS, VBUSMicro-USB, VIN, 3V3
Batterynonenone
Size21 × 51 mm28.2 × 51.8 mm
Logic3.3 V3.3 V

GPIO, ADC, DAC, touch, USB and power are counted from the board pinouts, without pins taken by flash and PSRAM. Cores, clock, RAM and radio: Raspberry Pi, RP2040 Datasheet; Raspberry Pi, Pico W Datasheet (CYW43439); Espressif, ESP32 Series Datasheet.

Compare Raspberry Pi Pico W with another board

Where the numbers in the table come from

GPIO, ADC, DAC, Touch, USB connector, power inputs and size are counted from the pinouts of the boards in the catalog. Free GPIOs are those without flash, PSRAM and lines used inside the board: on an ESP32 DevKit the flash pins GPIO6-11 are not counted.

Cores, clock speed, RAM, Wi-Fi and Bluetooth come from the datasheets of the chips and radio modules, and the source is named under the table. If a board runs below the chip's maximum frequency, like the 3.3 V Arduino Pro Mini at 8 MHz, the table shows the board's frequency.

Examples

  • ESP32 DevKitC V4 and ESP32-C3 SuperMini: the first has 2 Xtensa LX6 cores, 26 free GPIOs, 2 DAC outputs and 10 Touch pins; the second has 1 RISC-V core up to 160 MHz, 13 GPIOs and USB-C on an 18 × 22.52 mm board.
  • Arduino Uno R3 and Nano V3: one chip, an ATmega328P at 16 MHz. They differ in the USB connector (USB-B and mini-USB), the size and the number of pins.

FAQ

How is the ESP32 different from the ESP32-C3?
The ESP32 has two Xtensa LX6 cores up to 240 MHz, Bluetooth 4.2 with Classic mode, a DAC and Touch. The ESP32-C3 has one RISC-V core up to 160 MHz and Bluetooth 5 LE without Classic mode, and no DAC or Touch. The USB Serial/JTAG port is built into the C3 itself.

You might also need