microSD SPI module without regulator pinout

microSD SPI module without regulator, 3.3 V only (6 pins), microSD socket, 3.3 V logic, 18×18 mm, 6 pins

partly verified17.10.2026

No signal pin tolerates 5 V.

Top view, header on the left, card socket on the right (protrudes 3 mm).

Download PNG
Chip
microSD socket
Logic
3.3 V
Power
3V3 3-3.6 V

Important

  • 3.3 V only: for ESP32, Pico, STM32. With a 5 V Arduino you need a level shifter or a module with a regulator.
  • No pull-ups on the lines: if the card is not detected, add 10 kΩ from CS and MISO to 3.3 V.
  • Geometry from measuring the 18×18 board, header position approximate.

All pins

LabelNumberFunctionsLimitsCheck
3V33.3 Vpower inputnot verified
CSSPI CS of the card (SS)not 5 V tolerantnot verified
MOSISPI MOSInot 5 V tolerantnot verified
CLKSPI SCKnot 5 V tolerantnot verified
MISOSPI MISOnot 5 V tolerantnot verified
GNDGroundnot verified

Sources

Not verified against the manufacturer: 6 of 6 pins. The pin card says what confirms each one and where sources disagree.

Size: board 18×18 mm, 21 mm with the socket (Core Electronics measurement); batches differ (approximate).

FAQ

What supply voltage does the microSD SPI module without regulator need?
3V3: 3-3.6 V. 3.3 V logic.

You might also need

Similar boards