BME280 4 pins pinout
BME280 4 pins (VIN 3.3-5 V, GYBMEP), Bosch BME280, 5 V logic, 10.4×13.4 mm, 4 pins
partly verified15.10.2026
Front view (sensor side), connector at the bottom.
BuyDownload PNG- Chip
- Bosch BME280
- Logic
- 5 V
- Power
- VIN 3.3-5 V
- I2C address
- 0x76second 0x77
Important
- Supply 3.3-5 V, I2C lines through a level shifter: connects to an Arduino Uno directly.
- The address 0x76 or 0x77 is set by a jumper; the default differs between batches, so scan the bus.
- Geometry from independent KiCad footprints and photos (±0.3 mm). Holes and small components are approximate, check with calipers.
All pins
| Label | Number | Functions | Limits | Check |
|---|---|---|---|---|
| VIN | 5 V | power input | not from manufacturerModule without a manufacturer: the order follows the photo and two footprints; the default address (0x76 or 0x77) differs between batches. | |
| GND | Ground | not from manufacturerModule without a manufacturer: the order follows the photo and two footprints; the default address (0x76 or 0x77) differs between batches. | ||
| SCL | I2C SCL | not from manufacturerModule without a manufacturer: the order follows the photo and two footprints; the default address (0x76 or 0x77) differs between batches.Through the on-board level shifter: both 3.3 V and 5 V work. | ||
| SDA | I2C SDA | not from manufacturerModule without a manufacturer: the order follows the photo and two footprints; the default address (0x76 or 0x77) differs between batches.Through the on-board level shifter. |
Sources
Not verified against the manufacturer: 4 of 4 pins. The pin card says what confirms each one and where sources disagree.
- Bosch BME280 datasheet (BST-BME280-DS002, Rev 1.24)datasheet, checked 15.10.2026VDD 1.71–3.6 V, CSB to VDDIO = I2C, to ground = SPI, SDO selects the address 0x76/0x77, don't hold the interface high without power
- LastMinuteEngineers: BME280 Arduino tutorial (photo of the 4-pin board)third-party source, checked 15.10.2026order VIN, GND, SCL, SDA; regulator and level shifter on the board; address jumper
- KiCad: Polarisru/kicad6_library GY-BME280 and shyney7/kicad_lib BME280_4pinthird-party source, checked 15.10.2026size 13.4×10.4 (13.7×10.5), pin row centered 1.5 mm from the edge
Size: from two KiCad footprints (13.4×10.4 and 13.7×10.5) (approximate).
FAQ
- What is the I2C address of the BME280 4 pins?
- 0x76. The second address is 0x77: move the address jumper. SDA and SCL pull-ups are on the module.
- What supply voltage does the BME280 4 pins need?
- VIN: 3.3-5 V. 5 V logic.



