12×12 mm tactile button pinout

12×12 mm tactile button (4 pins), 12×12 tactile button, 5 V logic, 14.5×12.7 mm, 4 pins

partly verified17.10.2026

Top view: 4 top left, 3 top right, 2 bottom left, 1 bottom right (as in the Omron datasheet).

Download PNG
Chip
12×12 tactile button
Logic
5 V

Important

  • Pins 6.5 mm apart (12.5 mm on the 12×12) are always connected internally; the button joins them to the other pair. If both wires go to connected pins, the button reads as always pressed.
  • Simplest: one pin to a GPIO, the diagonal pin to GND, pinMode(pin, INPUT_PULLUP) in code: released = HIGH, pressed = LOW.
  • On a breadboard, place it across the center channel: the connected pins end up in different halves.

All pins

LabelNumberFunctionsLimitsCheck
4pin 4Pair 4–3 (connected internally)not from manufacturer
2pin 2Pair 2–1 (connected internally)not from manufacturer
3pin 3Pair 4–3 (connected internally)not from manufacturer
1pin 1Pair 2–1 (connected internally)not from manufacturer

Sources

Not verified against the manufacturer: 4 of 4 pins. The pin card says what confirms each one and where sources disagree.

  • Omron B3F Tactile Switch (6×6, 12×12)datasheet, checked 17.10.2026top view: pins 4 and 3 are connected, 2 and 1 are connected, the button is between the pairs; 6×6: pins 6.5 mm apart (connected) and 4.5 mm; 12×12 (B3F-4000): 12.5 and 5.0 mm; 50 mA, 24 V

Size: 12×12 body; pins 12.5×5.0 mm drawn at 12.7×5.08 (breadboard grid) (approximate).

You might also need

Similar boards