12 mm passive buzzer pinout
12 mm passive buzzer (needs PWM), Passive buzzer (coil), 5 V logic, 12.4×12.4 mm, 2 pins
partly verified17.10.2026
Top view, "+" on the left.
Download PNG- Chip
- Passive buzzer (coil)
- Logic
- 5 V
Important
- It does not beep on its own: it needs a 2–4 kHz signal, tone(pin, 2700) on Arduino or ledcWriteTone on ESP32.
- Coil 16–42 Ω: driven directly from a pin it draws 80–200 mA in pulses, which the pin cannot handle. Use a transistor (S8050, BC547) and a 1N4148 diode in parallel with the buzzer.
- How to tell it from an active one: the green board is visible from below, and on a battery it only clicks.
All pins
| Label | Number | Functions | Limits | Check |
|---|---|---|---|---|
| + | pin 1 | Coil lead, marked "+" | not from manufacturerBuzzers from kits can have a 16 Ω coil (up to 100 mA from 5 V): use a transistor. | |
| − | pin 2 | Second coil lead | not from manufacturerBuzzers from kits can have a 16 Ω coil (up to 100 mA from 5 V): use a transistor.Labelled on other revisions as: - |
Sources
Not verified against the manufacturer: 2 of 2 pins. The pin card says what confirms each one and where sources disagree.
- Same Sky (CUI Devices) CEM-1203(42) magnetic transducer (01/29/2025)datasheet, checked 17.10.2026Ø12×8.5 mm, no oscillator: 2048 Hz square wave, 3.5 V (up to 5 V), coil 42 Ω, 35–42 mA
Size: Ø12 mm, pins 7.6 mm apart drawn at 7.62 (approximate).

