Ebyte E01-ML01SP2 (nRF24L01) pinout
Ebyte E01-ML01SP2 (nRF24L01P, 20 dBm, SMD), nRF24L01P (Nordic), 3.3 V logic, 12.8×25 mm, 10 pins
verified15.10.2026
Top view (shield side), pads at the top, antenna at the bottom.
CompareDownload PNG- Chip
- nRF24L01P (Nordic)
- Logic
- 3.3 V
- Power
- VCC 2-3.6 V
Important
- The pin order is not like DIP modules: 1 VCC, 2 CE … 7 IRQ, 8 GND.
- 3.3 V only for supply and signals (Ebyte: 5 V TTL may burn it out).
- A module for soldering to a board (1.27 mm pitch), it does not fit a breadboard.
- Row offset: 1.80 mm from the edge by the drawing dimension, by the image scale the row is centered (1.955 mm). The difference is 0.15 mm.
- Transmit current 130 mA, receive 21 mA, sleep 1 µA.
All pins
| Label | Number | Functions | Limits | Check |
|---|---|---|---|---|
| VCC | pin 1 | 3.3 V | power input | verified2.0–3.6 V, above 3.6 V the module will burn out. |
| CE | pin 2 | CE: enables receive/transmit | not 5 V tolerant | verified |
| CSN | pin 3 | SPI CS (CSN) | not 5 V tolerant | verified |
| SCK | pin 4 | SPI SCK | not 5 V tolerant | verified |
| MOSI | pin 5 | SPI MOSI (module input) | not 5 V tolerant | verified |
| MISO | pin 6 | SPI MISO (module output) | verified | |
| IRQ | pin 7 | IRQ: interrupt (active low)to the MCU interrupt pin | verified | |
| GND | pin 8 | Ground | verified | |
| GND | pin 9 | Ground | verified | |
| GND | pin 10 | Ground | verified |
Sources
Every pin is verified against the manufacturer's documents.
- Nordic nRF24L01+ Product Specification v1.0 (SparkFun copy)datasheet, checked 15.10.2026pin functions CE, CSN, SCK, MOSI, MISO, IRQ; VDD 1.9–3.6 V; inputs tolerate 5 V (VIH up to 5.25 V) at VDD 2.7–3.3 V; TX current 11.3 mA at 0 dBm, RX 13.5 mA; supply decoupling
- Ebyte E01-ML01SP2 User Manual v1.7 (2025-07-11)datasheet, checked 15.10.2026size 12.8×25.0 mm, 8 half-holes at 1.27 pitch at the short edge (pin 8 is 1.80 mm from the edge in the bottom view), GND 9 and 10 on the long edges, pin functions, supply 2.0–3.6 V, 3.3 V level
Size: from the Ebyte drawing, thickness 2.1 mm.
FAQ
- What supply voltage does the Ebyte E01-ML01SP2 (nRF24L01) need?
- VCC: 2-3.6 V. 3.3 V logic.



