IRF3205 MOSFET pinout

IRF3205 MOSFET (N-channel, 55 V, 110 A, TO-220), IRF3205, 5 V logic, 10.2×23 mm, 3 pins

verified20.10.2026

View of the marking, tab at the top, pins down: G, D, S from left to right.

Download PNG
Chip
IRF3205
Logic
5 V

Important

  • Not a logic-level transistor: the threshold is 2-4 V, and 8 mΩ is promised only at 10 V on the gate. From the 3.3 V of an ESP32 the channel barely opens, from the 5 V of an Arduino it opens partly and heats up at high currents. The builder shows an error when the gate is driven from 3.3 V.
  • To drive it from an ESP32 or Arduino: a 10-12 V gate driver (TC4420, IR2104 for a bridge), an NPN transistor with the gate pulled up to 12 V, or an optocoupler. For small currents from 3.3 V, an IRLZ44N or AO3400 is simpler.
  • 110 A is the die limit with the case at 25 °C. Without a heatsink a TO-220 dissipates 1.5-2 W: at 10 V on the gate and 8 mΩ that is about 15 A.
  • Low-side switch: S to GND, load between the positive rail and D, 10–100 kΩ from gate to GND. For a motor or coil, add a diode with the cathode to the positive rail.
  • The tab is connected to the drain: mount the heatsink with an insulating pad if there are other parts on the heatsink.

Revisions and clones

  • IRF3205S (D2PAK) and IRF3205L (TO-262): same die, pins G, D, S.
  • IRLZ44N (part irlz44n-to220): same package and pin order, threshold 1-2 V, turns on from 5 V.

All pins

LabelNumberFunctionsLimitsCheck
Gpin 1Gate: 10 V from the driver; a 3.3–5 V GPIO does not fully turn it onverified
Dpin 2Drain: load negative (and the tab)verified
Spin 3Source: to GNDverified

Sources

Every pin is verified against the manufacturer's documents.

Size: TO-220 package 10×15.2 mm, pins shortened (approximate).

You might also need

Similar boards