IRFZ44N MOSFET pinout

IRFZ44N MOSFET (N-channel, 55 V, 49 A, TO-220), IRFZ44N, 5 V logic, 10.2×23 mm, 3 pins

verified20.10.2026

View of the marking, tab at the top, pins down: G, D, S from left to right.

Download PNG
Chip
IRFZ44N
Logic
5 V

Important

  • This is not a logic-level transistor: threshold Vgs(th) is 2-4 V, and 17.5 mΩ is guaranteed only at 10 V on the gate. From the 3.3 V of an ESP32 or Pico the channel will open partly or not at all, and the transistor gets hot and fails.
  • For ESP32 and Pico use an IRLZ44N (part irlz44n-to220) or add a gate driver: an NPN transistor with the gate pulled up to 10-12 V, an optocoupler or a driver chip.
  • From an Arduino (5 V) it is also not guaranteed: above 1-2 A check the heating.
  • Low-side switch: S to GND, load between the positive rail and D, 10–100 kΩ from gate to GND. For a motor or coil, add a diode with the cathode to the positive rail.
  • The tab is connected to the drain: mount a heatsink through an insulating pad.

Revisions and clones

  • IRLZ44N: same package and G, D, S order, threshold 1-2 V, opens from 5 V (part irlz44n-to220).

All pins

LabelNumberFunctionsLimitsCheck
Gpin 1Gate: 10 V from the driver; a 3.3–5 V GPIO does not fully turn it onverified
Dpin 2Drain: load negative (and the tab)verified
Spin 3Source: to GNDverified

Sources

Every pin is verified against the manufacturer's documents.

Size: TO-220 package 10×15.2 mm, pins shortened (approximate).

You might also need

Similar boards