LCD1602 I2C (PCF8574) pinout
LCD1602 display with an I2C adapter on PCF8574 (0x27 / 0x3F), HD44780 + PCF8574T, 5 V logic, 80×36 mm, 4 pins
partly verified17.10.2026
Front view (screen side), I2C header on the left.
BuyDownload PNG- Chip
- HD44780 + PCF8574T
- Logic
- 5 V
- Power
- VCC 4.5-5.5 V
- I2C address
- 0x27second 0x3F
Important
- Address: PCF8574T is 0x27, PCF8574AT is 0x3F. If you do not know, run an I2C scanner.
- 5 V supply. The adapter's pull-ups pull SDA and SCL to 5 V: with an ESP32 or Pico use a level shifter (or desolder the pull-ups and add 4.7 kΩ to 3.3 V).
- Contrast is a trimmer on the adapter (wiper): without adjusting it, on first power-up you often see only rectangles or nothing.
- LiquidCrystal_I2C library (lcd.init(), lcd.backlight()).
All pins
| Label | Number | Functions | Limits | Check |
|---|---|---|---|---|
| GND | Ground | not from manufacturerLabels per Handsontec and photos of FC-113 adapters; there is no schematic from the adapter manufacturer. | ||
| VCC | 5 V | power input | not from manufacturerLabels per Handsontec and photos of FC-113 adapters; there is no schematic from the adapter manufacturer. | |
| SDA | I2C SDA | not from manufacturerLabels per Handsontec and photos of FC-113 adapters; there is no schematic from the adapter manufacturer.The adapter has 4.7 kΩ pull-ups to VCC (5 V): for ESP32 and Pico use a level shifter or remove the pull-ups. | ||
| SCL | I2C SCL | not from manufacturerLabels per Handsontec and photos of FC-113 adapters; there is no schematic from the adapter manufacturer. |
Sources
Not verified against the manufacturer: 4 of 4 pins. The pin card says what confirms each one and where sources disagree.
- Handsontec I2C Serial Interface 1602 LCD Modulethird-party source, checked 17.10.2026PCF8574T is address 0x27, PCF8574AT is 0x3F (A0-A2 not soldered); board 80×36 mm; pins GND, VCC, SDA, SCL; 5 V
- TI PCF8574 Remote 8-Bit I/O Expander for I2C Busdatasheet, checked 17.10.2026address 0100 A2 A1 A0 (0x20-0x27); PCF8574A is 0111 A2 A1 A0 (0x38-0x3F); supply 2.5-6 V
Size: 80×36 mm (Handsontec); the adapter header sticks out on the left (approximate).
FAQ
- What is the I2C address of the LCD1602 I2C (PCF8574)?
- 0x27. The second address is 0x3F: an adapter on the PCF8574AT answers at 0x3F; on the PCF8574T the address is changed with jumpers A0-A2 (0x20-0x27). SDA and SCL pull-ups are on the module.
- What supply voltage does the LCD1602 I2C (PCF8574) need?
- VCC: 4.5-5.5 V. 5 V logic.



