GL5528 photoresistor pinout
GL5528 photoresistor (5 mm, 10-20 kΩ at 10 lux), CdS photoresistor, 5 V logic, 5.6×10 mm, 2 pins
verified22.10.2026
View of the light-sensitive side, leads down.
BuyDownload PNG- Chip
- CdS photoresistor
- Logic
- 5 V
Important
- No polarity. For an Arduino it goes into a voltage divider: the photoresistor from 5V to A0, a 10 kΩ resistor from A0 to GND. The brighter the light, the higher the voltage on A0.
- The resistance falls with light roughly as R = R10 × (E / 10 lux)^−0.6: about 4 kΩ at 100 lux, over 1 MΩ in the dark.
- The spread between units is 10-20 kΩ at 10 lux: set the night-light threshold for your own photoresistor by watching the analogRead() numbers.
All pins
Sources
Every pin is verified against the manufacturer's documents.
- Rapid Online 58-0134: GL5528 Light Dependent Photoresistor (per the Senba GL55 tables)datasheet, checked 22.10.202610-20 kΩ at 10 lux, dark resistance 1 MΩ, γ 0.6, up to 150 V and 100 mW, Φ5.1 mm, leads 3.0 mm apart
Size: Φ5.1 mm body; leads 3.0 mm apart are drawn at 2.54 (adjacent breadboard holes) (approximate).


