18650 battery in a 1-cell holder pinout
18650 battery in a 1-cell holder (3.7 V, with wires), Li-ion 18650, 1 pcs., 3.7 V logic, 88×21 mm, 2 pins
partly verified17.10.2026
Top view, wires on the left, battery positive on the right.
BuyDownload PNG- Chip
- Li-ion 18650, 1 pcs.
- Logic
- 3.7 V
- Power
- + (battery output) 3-4.2 V
Important
- Cell without protection: add a charging board with protection (TP4056 with DW01) or a 1S BMS.
- For 5 V you need a boost module (MT3608), for 3.3 V a low-dropout regulator (HT7333, MCP1700). An AMS1117 gives less than 3.3 V from 3.7 V.
- Some 18650 cells have built-in protection (longer, 67–69 mm): they may not fit a short holder.
- Holder with no manufacturer: dimensions from typical holders ±1 mm, wires drawn shorter than real ones (usually 10–15 cm).
- Source: 3.0–4.2 V. Do not connect directly to the 3V3 of a board: it is 4.2 V when fully charged.
Revisions and clones
- 2-cell series holder (7.4 V): entry battery-18650-holder-2.
- PCB-mount holders without wires (Keystone 1042 and clones): same "+" and "−", pins go into holes.
All pins
| Label | Number | Functions | Limits | Check |
|---|---|---|---|---|
| + | 3.7 V | power output | not from manufacturerHolder with no maker: wire colors (red positive) follow the usual convention, but check against the "+" marks in the holder.Battery positive: 3.0–4.2 V, unregulated. Without a protection board, over-discharge below 2.5 V ruins the cell.Labelled on other revisions as: BAT+, red wire | |
| - | Ground | not from manufacturerHolder with no maker: wire colors (red positive) follow the usual convention, but check against the "+" marks in the holder.Battery negative. Connect to the circuit GND (or to B− of the protection board).Labelled on other revisions as: −, BAT-, black wire |
Sources
Not verified against the manufacturer: 2 of 2 pins. The pin card says what confirms each one and where sources disagree.
- Battery University BU-205: Types of Lithium-ion (Li-ion 3.6–3.7 V, charge 4.2 V, discharge down to 2.5–3.0 V)third-party source, checked 17.10.2026nominal 3.6–3.7 V, charge up to 4.2 V, lower limit 2.5–3.0 V
- Adafruit: Lithium Ion Polymer Battery 3.7V 1200mAh (product 258)datasheet, checked 17.10.20263.7 V nominal, 4.2 V fully charged, protection cuts off at 3.0 V, JST-PH 2-pin connector, "other sellers may use reverse polarity", 2 A wires, 34×62×5 mm
Size: holder 77×21 mm on typical models, wires on the left (shortened) (approximate).



