Two 18650 cells in a holder in series pinout
Two 18650 cells in a holder in series (7.4 V, with wires), Li-ion 18650, 2 pcs in series (2S), 7.4 V logic, 88×41 mm, 2 pins
partly verified17.10.2026
Top view, wires on the left.
Download PNG- Chip
- Li-ion 18650, 2 pcs in series (2S)
- Logic
- 7.4 V
- Power
- + (pack output) 6-8.4 V
Important
- A series pack without balancing drifts apart in voltage over time: charging needs a 2S BMS (B−, BM, B+) and an 8.4 V charger.
- From 7.4 V: an LM7805 (needs 7 V or more) gets hot, a buck module (LM2596, MP1584) is better.
- Holder with no manufacturer: dimensions from typical holders ±1 mm, wires drawn shorter than real ones (usually 10–15 cm).
- 6-8.4 V source: to Arduino VIN, to L298N, to a buck module. Charge only with a 2S balancing charger (2S BMS).
Revisions and clones
- 2-cell holders with a middle tap (three wires) are for a 2S BMS, the middle wire goes to BM.
All pins
| Label | Number | Functions | Limits | Check |
|---|---|---|---|---|
| + | 7.4 V | power output | not from manufacturerNo-name holder. There are 2-cell holders with parallel connection (3.7 V): check with a multimeter.Pack positive: 6.0-8.4 V. The cells in the holder are connected in series.Labelled on other revisions as: BAT+, red wire | |
| - | Ground | not from manufacturerNo-name holder. There are 2-cell holders with parallel connection (3.7 V): check with a multimeter.Battery negative. Connect to the circuit GND (or to B− of the protection board).Labelled on other revisions as: −, BAT-, black wire |
Sources
Not verified against the manufacturer: 2 of 2 pins. The pin card says what confirms each one and where sources disagree.
- Battery University BU-205: Types of Lithium-ionthird-party source, checked 17.10.2026cell nominal 3.6-3.7 V, charged to 4.2 V
Size: holder 77×41 mm for typical models, wires on the left (shortened) (approximate).



