2×AA battery holder pinout
2×AA battery holder (3 V, with wires), 2 × AA alkaline in series, 3 V logic, 70×31 mm, 2 pins
partly verified17.10.2026
Top view, wires on the left.
Download PNG- Chip
- 2 × AA alkaline in series
- Logic
- 3 V
- Power
- + (holder output) 2-3.2 V
Important
- Alkaline batteries handle high current poorly: at 500 mA the capacity is 2–3 times lower than rated. Rechargeable cells are better for motors and Wi-Fi.
- The internal resistance of batteries rises toward the end of discharge: at a current peak (Wi-Fi, motor) the voltage sags and the board resets.
- Holder with no manufacturer: dimensions from typical holders ±1 mm, wires drawn shorter than real ones (usually 10–15 cm).
- 2×AA can feed 3V3 directly on an ESP32 and other 3.3 V chips (3.2 V when fresh), but near the end the voltage drops below 2.7 V and the chip resets.
Revisions and clones
- 3×AA holder (4.5 V): see the battery-holder-3xaa entry.
- Holders with a lid and a switch: the switch is in the positive line.
All pins
| Label | Number | Functions | Limits | Check |
|---|---|---|---|---|
| + | 3 V | power output | not from manufacturerHolder with no manufacturer: the red wire is positive by common marking. Some holders have a switch on the lid.Positive: 2.0–3.2 V (alkaline). With NiMH cells 2.4 V.Labelled on other revisions as: BAT+, red wire | |
| - | Ground | not from manufacturerHolder with no manufacturer: the red wire is positive by common marking. Some holders have a switch on the lid.Battery negative. Connect to the circuit GND (or to B− of the protection board).Labelled on other revisions as: −, BAT-, black wire |
Sources
Not verified against the manufacturer: 2 of 2 pins. The pin card says what confirms each one and where sources disagree.
- Energizer E91 (AA, alkaline) datasheetdatasheet, checked 17.10.20261.5 V nominal, capacity about 2500–3000 mAh at low current, much less at hundreds of mA, discharge down to 0.8–1.0 V
Size: holder about 58×31 mm, wires on the left (shortened) (approximate).
You might also need
Similar boards

18650 battery in a 1-cell holder (3.7 V, with wires)
Li-ion 18650, 1 pcs.2 pins

Two 18650 cells in a holder in series (7.4 V, with wires)
Li-ion 18650, 2 pcs in series (2S)2 pins

9 V PP3 battery (6LR61) with clip
Alkaline 9 V (6LR61)2 pins

3×AA battery holder (4.5 V, with wires)
3 × AA alkaline in series2 pins