9 V PP3 battery with clip pinout
9 V PP3 battery (6LR61) with clip, Alkaline 9 V (6LR61), 9 V logic, 64×26.5 mm, 2 pins
partly verified17.10.2026
Side view, clip on the left.
Download PNG- Chip
- Alkaline 9 V (6LR61)
- Logic
- 9 V
- Power
- + (battery output) 6-9.6 V
Important
- The 9 V battery is a poor source for an Arduino and even worse for motors and Wi-Fi: small capacity and high internal resistance. A servo powered from it through an LM7805 will reset the board.
- An LM7805 from 9 V at 100 mA dissipates 0.4 W, which is fine; at 500 mA it dissipates 2 W and needs a heatsink.
- 6-9.5 V source for the Arduino VIN or a regulator input. The capacity is small: an Arduino Uno (about 50 mA) runs for 8-10 hours.
All pins
| Label | Number | Functions | Limits | Check |
|---|---|---|---|---|
| + | 9 V | power output | not from manufacturerClip without a manufacturer: red is positive by the usual marking.Positive: 6-9.5 V. Through an LM7805 or a buck module, or to the Arduino VIN.Labelled on other revisions as: BAT+, red wire | |
| - | Ground | not from manufacturerClip without a manufacturer: red is positive by the usual marking.Battery negative. Connect to the circuit GND (or to B− of the protection board).Labelled on other revisions as: −, BAT-, black wire |
Sources
Not verified against the manufacturer: 2 of 2 pins. The pin card says what confirms each one and where sources disagree.
- Energizer 522 (9 V, alkaline) datasheetdatasheet, checked 17.10.20269 V nominal, about 600 mAh at low current, size 48.5×26.5×17.5
Size: battery 48.5×26.5×17.5 mm, clip and wires on the left (shortened) (approximate).
You might also need
Similar boards

18650 battery in a 1-cell holder (3.7 V, with wires)
Li-ion 18650, 1 pcs.2 pins

Two 18650 cells in a holder in series (7.4 V, with wires)
Li-ion 18650, 2 pcs in series (2S)2 pins

2×AA battery holder (3 V, with wires)
2 × AA alkaline in series2 pins

3×AA battery holder (4.5 V, with wires)
3 × AA alkaline in series2 pins