3×AA battery holder pinout
3×AA battery holder (4.5 V, with wires), 3 × AA alkaline in series, 4.5 V logic, 70×46 mm, 2 pins
partly verified17.10.2026
Top view, wires on the left.
Download PNG- Chip
- 3 × AA alkaline in series
- Logic
- 4.5 V
- Power
- + (holder output) 3-4.8 V
Important
- Alkaline batteries handle high current poorly: at 500 mA the capacity is 2–3 times lower than rated. Rechargeable cells are better for motors and Wi-Fi.
- The internal resistance of batteries rises toward the end of discharge: at a current peak (Wi-Fi, motor) the voltage sags and the board resets.
- Holder with no manufacturer: dimensions from typical holders ±1 mm, wires drawn shorter than real ones (usually 10–15 cm).
- 4.5 V: too low for 5 V boards (after a regulator), too high for 3V3. Feed it through a low-dropout 3.3 V regulator or into the board's 5V input where it does not go through an AMS1117.
Revisions and clones
- The 2×AA holder (3 V) is the entry battery-holder-2xaa.
- Holders with a lid and a switch: the switch is in the positive line.
All pins
| Label | Number | Functions | Limits | Check |
|---|---|---|---|---|
| + | 4.5 V | power output | not from manufacturerHolder with no manufacturer: the red wire is positive by common marking. Some holders have a switch on the lid.Positive: 3.0-4.8 V (alkaline). With NiMH cells 3.6 V.Labelled on other revisions as: BAT+, red wire | |
| - | Ground | not from manufacturerHolder with no manufacturer: the red wire is positive by common marking. Some holders have a switch on the lid.Battery negative. Connect to the circuit GND (or to B− of the protection board).Labelled on other revisions as: −, BAT-, black wire |
Sources
Not verified against the manufacturer: 2 of 2 pins. The pin card says what confirms each one and where sources disagree.
- Energizer E91 (AA, alkaline) datasheetdatasheet, checked 17.10.20261.5 V nominal, capacity about 2500–3000 mAh at low current, much less at hundreds of mA, discharge down to 0.8–1.0 V
Size: holder about 58×46 mm, wires on the left (shortened) (approximate).
You might also need
Similar boards

18650 battery in a 1-cell holder (3.7 V, with wires)
Li-ion 18650, 1 pcs.2 pins

Two 18650 cells in a holder in series (7.4 V, with wires)
Li-ion 18650, 2 pcs in series (2S)2 pins

9 V PP3 battery (6LR61) with clip
Alkaline 9 V (6LR61)2 pins

2×AA battery holder (3 V, with wires)
2 × AA alkaline in series2 pins