DD4012SA mini buck module for 5 V pinout
DD4012SA mini buck module for 5 V (up to 1 A, 3 pins), unmarked (controller in SOT-23-6), 5 V logic, 16×11 mm, 3 pins
partly verified17.10.2026
Top view, pins on the left.
Download PNG- Chip
- unmarked (controller in SOT-23-6)
- Logic
- 5 V
- Power
- VIN 6.5-40 V
Important
- A handy replacement for the LM7805 and AMS1117: it doesn't get hot from 12 V. The input must be 1.5–2 V above the output.
- 3.3 V and 5 V modules look the same: check the marking on the board or measure the output with no load.
- Geometry from seller descriptions (±0.5 mm), components drawn approximately. Check with calipers before laying out your own board.
- Fixed output, no trimmer.
All pins
| Label | Number | Functions | Limits | Check |
|---|---|---|---|---|
| VIN | 12 V | power input | not verifiedVIN, GND, VOUT order follows the description of a similar module; for the DD4012SA the labels in the photo were not verified, size not dimensioned. Read the labels on the board.Input up to 40 V. | |
| GND | Ground | not verifiedVIN, GND, VOUT order follows the description of a similar module; for the DD4012SA the labels in the photo were not verified, size not dimensioned. Read the labels on the board.Common negative of input and output. | ||
| VOUT | 5 V | power output | not verifiedVIN, GND, VOUT order follows the description of a similar module; for the DD4012SA the labels in the photo were not verified, size not dimensioned. Read the labels on the board.5 V output, up to 1 A (for long runs keep to 0.6–0.8 A).Labelled on other revisions as: OUT, 5V |
Sources
Not verified against the manufacturer: 3 of 3 pins. The pin card says what confirms each one and where sources disagree.
- GrabCAD: DD4012SA 6.5-40V to 3.3V 5V DC-DC Step-Down Buck Converter 1Athird-party source, checked 17.10.2026input 6.5–40 V, output 3.3 or 5 V, 1 A, 1×3 header
- Cirkit Designer: 5–12V to 3.3V fixed output DC-DC step-downthird-party source, checked 17.10.2026three pins VIN, GND, VOUT on a similar module
Size: about 16×11 mm from seller photos, not dimensioned (approximate).
You might also need
Similar boards

Boost module 0.9–5 V → 5 V with a USB socket (600 mA)
unmarked (boost controller, SOT-23)4 pins

DD4012SA mini buck module, 3.3 V (up to 1 A, 3 pins)
unmarked (controller in SOT-23-6)3 pins

LM2596 buck module (blue 43×21, trimmer, up to 2-3 A)
LM2596S-ADJ4 pins

MP1584EN mini step-down module (22×17, 1.5–3 A)
MP1584EN4 pins