CR2032 battery in a PCB holder pinout
CR2032 battery in a PCB holder (3 V), Lithium CR2032, 3 V logic, 24×21 mm, 2 pins
partly verified17.10.2026
Top view, positive pin on the left, negative under the battery.
BuyDownload PNG- Chip
- Lithium CR2032
- Logic
- 3 V
- Power
- + (battery output) 2-3.2 V
Important
- CR2032 suits clocks (DS3231), sensors that sleep, small transmitters. Wi-Fi and Bluetooth boards don't survive on it: at 100 mA the voltage drops below 2 V.
- It handles current pulses up to 15 mA better with a 100–470 µF capacitor in parallel.
- Don't charge it: it's a primary lithium cell (reverse current no more than 1 µA per Energizer).
- Small currents only: continuous up to 0.2–3 mA, pulses up to 7–15 mA. An ESP32 with Wi-Fi (hundreds of mA) doesn't run from a CR2032.
All pins
| Label | Number | Functions | Limits | Check |
|---|---|---|---|---|
| + | 3 V | power output | not from manufacturerThere are many holders (BS-6, BS-7, Keystone 103/3034) and their pin positions differ: the drawing is schematic. Positive is the side clip, negative is the contact under the battery.Battery positive (top side of the coin cell, with the text). 2.0–3.2 V.Labelled on other revisions as: BAT+, + | |
| - | Ground | not from manufacturerThere are many holders (BS-6, BS-7, Keystone 103/3034) and their pin positions differ: the drawing is schematic. Positive is the side clip, negative is the contact under the battery.Battery negative. Connect to the circuit GND (or to B− of the protection board).Labelled on other revisions as: BAT-, − |
Sources
Not verified against the manufacturer: 2 of 2 pins. The pin card says what confirms each one and where sources disagree.
- Energizer CR2032 datasheetdatasheet, checked 17.10.20263.0 V, 235 mAh down to 2.0 V at a 0.19 mA background load, pulses about 6.8 mA, 3 g
Size: holder about 24×21 mm for a Ø20 battery; pin positions approximate (approximate).
You might also need
Similar boards

18650 battery in a 1-cell holder (3.7 V, with wires)
Li-ion 18650, 1 pcs.2 pins

Two 18650 cells in a holder in series (7.4 V, with wires)
Li-ion 18650, 2 pcs in series (2S)2 pins

9 V PP3 battery (6LR61) with clip
Alkaline 9 V (6LR61)2 pins

2×AA battery holder (3 V, with wires)
2 × AA alkaline in series2 pins