DHT22 module on a board pinout

DHT22 (AM2302) module on a board (+, out, −), DHT22 (AM2302), 3.3 V logic, 20×31.5 mm, 3 pins

partly verified20.10.2026

Top view, sensor on top, header at the bottom: +, out, − from left to right.

BuyDownload PNG
Chip
DHT22 (AM2302)
Logic
3.3 V
Power
+ 3.3-5.5 V

Important

  • To an ESP32: + to 3V3, out to a GPIO that has an output (not 34-39), − to GND. The pull-up is on the board.
  • To an Arduino: + to 5V, out to D2.
  • Poll no more than once every 2 seconds; the library type is DHT22.
  • The board and parts are drawn from a photo, the dimensions are not measured.

Revisions and clones

  • Boards labeled VCC, DAT, GND or S, +, − (KY style) exist: check the order by the labels.

All pins

LabelNumberFunctionsLimitsCheck
+3.3 Vpower inputnot from manufacturer
outDHT22 data (Aosong bus)onboard pull-upnot from manufacturer
-Groundnot from manufacturer

Sources

Not verified against the manufacturer: 3 of 3 pins. The pin card says what confirms each one and where sources disagree.

Size: sellers list about 22×28 mm; the board, sensor and header are drawn from a photo, not dimensioned (approximate).

FAQ

What supply voltage does the DHT22 module on a board need?
+: 3.3-5.5 V. 3.3 V logic.

You might also need

Similar boards