HLK-LD2410C pinout
HLK-LD2410C, 24 GHz presence radar (UART and OUT), 24 GHz FMCW radar, 3.3 V logic, 22×16 mm, 5 pins
verified17.10.2026
View from the antenna side, pin holes at the top.
BuyDownload PNG- Chip
- 24 GHz FMCW radar
- Logic
- 3.3 V
- Power
- VCC 5-12 V
Important
- UART at 256000 baud: SoftwareSerial on Arduino Uno and Nano cannot handle that, a hardware UART is needed (ESP32, Mega, Pico). The speed can be changed with a command.
- The OUT pin can be read without UART: high while a person is in the zone.
- 5 V supply from a source of 200 mA or more; pin levels are 3.3 V.
- Horizontal hole positions were measured from the Hi-Link drawing (±0.3 mm); the 2.54 distance from the edge and the pitch are dimensioned.
- Configure over Bluetooth with the HLKRadarTool app or over UART (ESPHome ld2410).
Revisions and clones
- HLK-LD2410 and LD2410B: 1.25 mm connector and 7×35 mm size, different modules.
- LD2410S: a different protocol and 3.3 V supply.
All pins
| Label | Number | Functions | Limits | Check |
|---|---|---|---|---|
| TX | Module UART TX: 256000 baud, 8N1 | verifiedTo the board's RX.Labelled on other revisions as: UART_Tx | ||
| RX | Module UART RX | not 5 V tolerant | verified3.3 V level: from a 5 V Arduino TX use a divider (the manufacturer does not state 5 V tolerance).Labelled on other revisions as: UART_Rx | |
| OUT | verified | |||
| GND | Ground | verified | ||
| VCC | 5 V | power input | verified |
Sources
Every pin is verified against the manufacturer's documents.
- Hi-Link HLK-LD2410C manual v1.00 (sudo.is copy)user guide, checked 17.10.202616×22 board, 5 holes Ø0.9 at 2.54 pitch, 2.54 mm from the edge, header pins not soldered at the factory; pins TX, RX, OUT, GND, VCC; VCC 5-12 V (5 recommended), 3.3 V levels, average current 79 mA, supply > 200 mA
- Hi-Link HLK-LD2410C serial communication protocol v1.00datasheet, checked 17.10.2026pin table, UART 256000 baud, 1 stop bit, no parity; OUT high when presence is detected
Size: 22×16 per the Hi-Link drawing (the specification table in the same manual wrongly says 7×35, which is the LD2410B size).
FAQ
- What supply voltage does the HLK-LD2410C need?
- VCC: 5-12 V. 3.3 V logic.



