LiPo 1S 3.7 V battery with a JST-PH 2.0 connector pinout
LiPo 1S 3.7 V battery with a JST-PH 2.0 connector (1200 mAh), Li-polymer 1S, 3.7 V logic, 77×34 mm, 2 pins
partly verified17.10.2026
Top view, JST-PH connector on the left.
BuyDownload PNG- Chip
- Li-polymer 1S
- Logic
- 3.7 V
- Power
- + (battery output) 3-4.2 V
Important
- POLARITY: the red wire is positive on Adafruit and SparkFun; on Chinese batteries the wires in the connector may be swapped. With reversed polarity the charger board burns out. Before connecting, check the "+" and "−" marks on the board against the wires.
- Charge only with a Li-ion board for 4.2 V (TP4056, MCP73831, IP5306). Charge current no more than the capacity (1200 mAh: up to 1.2 A), preferably half.
- For 3.3 V use a low-dropout regulator (HT7333, MCP1700, ME6211 on ESP32-C3 and Wemos boards); for 5 V use a boost module.
- The capacity in the name is often overstated on unbranded batteries: count on 70-80 % of the label.
- 3.0-4.2 V source via JST-PH 2.0. Check the connector polarity before connecting: it is sometimes reversed on Chinese batteries.
Revisions and clones
- Other sizes (502030: 250 mAh, 103450: 2000 mAh): the same pins, different capacity (enter it in the power budget).
All pins
| Label | Number | Functions | Limits | Check |
|---|---|---|---|---|
| + | 3.7 V | power output | not from manufacturerThe connector polarity on Adafruit and SparkFun matches (red is positive), but on some Chinese batteries the wires in the connector are swapped. Check the wire colors and the "+" mark on the charger board.Positive: 3.0-4.2 V. Do not connect directly to the board's 3V3: it is 4.2 V when fully charged.Labelled on other revisions as: BAT+, red wire | |
| - | Ground | not from manufacturerSee the polarity at the positive pin.Labelled on other revisions as: −, BAT-, black wire |
Sources
Not verified against the manufacturer: 2 of 2 pins. The pin card says what confirms each one and where sources disagree.
- Adafruit: Lithium Ion Polymer Battery 3.7V 1200mAh (product 258)datasheet, checked 17.10.20263.7 V nominal, 4.2 V fully charged, protection cuts off at 3.0 V, JST-PH 2-pin connector, "other sellers may use reverse polarity", 2 A wires, 34×62×5 mm
Size: battery 62×34×5 mm (Adafruit 1200 mAh), wires and connector on the left (shortened) (approximate).
You might also need
Similar boards

18650 battery in a 1-cell holder (3.7 V, with wires)
Li-ion 18650, 1 pcs.2 pins

Two 18650 cells in a holder in series (7.4 V, with wires)
Li-ion 18650, 2 pcs in series (2S)2 pins

9 V PP3 battery (6LR61) with clip
Alkaline 9 V (6LR61)2 pins

2×AA battery holder (3 V, with wires)
2 × AA alkaline in series2 pins