N20 gear motor pinout
N20 gear motor (12×10 mm), 2 pins, 3–12 V brushed motor with a gearbox, 5 V logic, 48×12 mm, 2 pins
partly verified17.10.2026
Side view (12 mm wide face), pins on the left, shaft on the right.
BuyDownload PNG- Chip
- 3–12 V brushed motor with a gearbox
- Logic
- 5 V
- Power
- M1 and M2 through a driver
Important
- Current depends on the winding: Adafruit 6 V about 100 mA (200 mA stalled), Waveshare 12 V up to 1.1 A stalled. Choose the driver by the stall current.
- Brush noise: 0.1 µF ceramic capacitor across the motor terminals.
All pins
| Label | Number | Functions | Limits | Check |
|---|---|---|---|---|
| M1 | Motor pin M1: to the driver output | not from manufacturerA plain part with no pinout: two motor terminals, no labels. Body dimensions per Pololu, current depends on the winding.Connect the motor only through a driver (DRV8833, TB6612, L298N) or a transistor with a diode: a GPIO gives up to 20 mA.Swapping M1 and M2 reverses the motor direction.Labelled on other revisions as: +, red | ||
| M2 | Motor pin M2: to the driver output | not from manufacturerA plain part with no pinout: two motor terminals, no labels. Body dimensions per Pololu, current depends on the winding.Connect the motor only through a driver (DRV8833, TB6612, L298N) or a transistor with a diode: a GPIO gives up to 20 mA.Swapping M1 and M2 reverses the motor direction.Labelled on other revisions as: −, black |
Sources
Not verified against the manufacturer: 2 of 2 pins. The pin card says what confirms each one and where sources disagree.
- Pololu: micro metal gearmotor (N20 format), dimensionsthird-party source, checked 17.10.2026body 12×10 mm, gearbox 9 mm, motor 15 mm, shaft Ø3 with a flat
- Adafruit: N20 DC Motor with Magnetic Encoder - 6V 1:50 (4638)third-party source, checked 17.10.2026motor supply 4.5–6 V, about 100 mA, 200 mA stalled; encoder 3–5 V, two Hall outputs; wire colors
Size: motor 15 mm, gearbox 9 mm, shaft 10 mm per Pololu; wires are schematic (approximate).
You might also need
Similar boards

Motor 130 (toy, 4.5-9 V), 2 pins
brushed motor without gearbox2 pins

N20 gear motor with Hall encoder, 6 pins
brushed motor with gearbox and magnetic encoder6 pins

A4988 stepper motor driver (StepStick, Pololu and clones)
Allegro A498816 pins

DRV8825 stepper motor driver (StepStick, Pololu and clones)
TI DRV882516 pins