Motor 130 pinout
Motor 130 (toy, 4.5-9 V), 2 pins, brushed motor without gearbox, 5 V logic, 40×20 mm, 2 pins
partly verified22.10.2026
Side view (20 mm face), pins on the left, shaft on the right.
BuyDownload PNG- Chip
- brushed motor without gearbox
- Logic
- 5 V
- Power
- M1 and M2 through a transistor or driver
Important
- Do not connect to an Arduino pin directly: a pin gives up to 20 mA. Use a transistor (logic-level MOSFET IRLZ44N, 2N2222A up to 500 mA) and a 1N4007 diode across the motor, stripe to positive.
- Power the motor separately, with the negative shared with the board GND. From the board 5V the motor sags the supply at start-up and the board resets.
- Brush noise: 0.1 µF ceramic capacitor across the motor terminals.
All pins
| Label | Number | Functions | Limits | Check |
|---|---|---|---|---|
| M1 | Motor pin M1: to the driver output | not from manufacturerA plain part with no pinout: two tabs, no labels (some have a red dot near the positive). Current varies between unbranded 130 motors, and for 3 V motors the stall current is above 1 A.Connect the motor only through a driver (DRV8833, TB6612, L298N) or a transistor with a diode: a GPIO gives up to 20 mA.Swapping M1 and M2 reverses the motor direction.Labelled on other revisions as: +, red dot | ||
| M2 | Motor pin M2: to the driver output | not from manufacturerA plain part with no pinout: two tabs, no labels (some have a red dot near the positive). Current varies between unbranded 130 motors, and for 3 V motors the stall current is above 1 A.Connect the motor only through a driver (DRV8833, TB6612, L298N) or a transistor with a diode: a GPIO gives up to 20 mA.Swapping M1 and M2 reverses the motor direction.Labelled on other revisions as: − |
Sources
Not verified against the manufacturer: 2 of 2 pins. The pin card says what confirms each one and where sources disagree.
- Adafruit: DC Toy / Hobby Motor - 130 Size (711)third-party source, checked 22.10.20264.5-9 V, 6 V nominal; no load up to 70 mA and 9100 rpm; under load up to 250 mA; stalled up to 500 mA; body 27.5×20×15 mm, shaft 8 mm Φ2
Size: body 27.5×20×15 mm, shaft 8 mm Φ2 per Adafruit 711; pins are schematic (approximate).
You might also need
Similar boards

N20 gear motor (12×10 mm), 2 pins
3–12 V brushed motor with a gearbox2 pins

N20 gear motor with Hall encoder, 6 pins
brushed motor with gearbox and magnetic encoder6 pins

A4988 stepper motor driver (StepStick, Pololu and clones)
Allegro A498816 pins

DRV8825 stepper motor driver (StepStick, Pololu and clones)
TI DRV882516 pins