Speaker 4–8 Ω pinout
Speaker 4–8 Ω, Ø40 mm, 2 pins, dynamic driver, 5 V logic, 56×40 mm, 2 pins
partly verified17.10.2026
Front view (cone facing the viewer), pins on the left.
BuyDownload PNG- Chip
- dynamic driver
- Logic
- 5 V
- Power
- from the amplifier output
Important
- Don't connect it directly to a GPIO: the coil is 4–8 Ω. You need an amplifier (MAX98357A over I2S, PAM8403 for analog) or a transistor.
- The driver's power rating must be at least the amplifier's power at that impedance: the MAX98357A at 5 V gives up to 3.2 W into 4 Ω and 1.8 W into 8 Ω.
All pins
| Label | Number | Functions | Limits | Check |
|---|---|---|---|---|
| + | Voice coil terminal "+" (marked red or with a + sign) | not from manufacturerA plain part with no pinout: two voice coil terminals. Wire color and the "+" mark vary between manufacturers.Polarity matters only for phase (two speakers as a pair); connect to "+" on an amplifier with a bridge output. | ||
| − | Voice coil terminal "-" | not from manufacturerA plain part with no pinout: two voice coil terminals. Wire color and the "+" mark vary between manufacturers.Labelled on other revisions as: - |
Sources
Not verified against the manufacturer: 2 of 2 pins. The pin card says what confirms each one and where sources disagree.
- Adafruit: Speaker - 40mm Diameter - 4 Ohm (3968)third-party source, checked 17.10.2026Ø40 mm, height 20 mm, 4 Ω, 3 W (up to 5 W per the 2024 revision)
- Adafruit Learn: MAX98357, speaker requirementsthird-party source, checked 17.10.2026speaker of 4 Ω or more, voice coil terminals to "+" and "-" of the amplifier
Size: the Ø40 mm driver is drawn after Adafruit 3968; wires and their ends are schematic (approximate).



