MG90S servo pinout
MG90S servo (TowerPro, metal gears), PWM-controlled servo, 5 V logic, 46.5×12.6 mm, 3 pins
partly verified17.10.2026
Top view, wire connector on the left.
BuyDownload PNG- Chip
- PWM-controlled servo
- Logic
- 5 V
- Power
- VCC (red) 4.8-6 V
Important
- Supply 4.8–6 V. Control is the same as the SG90: 50 Hz, 1–2 ms pulse.
- The size differs between two TowerPro documents: 22.8×12.2×28.5 (website) and 22.5×12×35.5 (sheet with the shaft).
- Stall current is higher than the SG90: from the board's 5V pin on USB, power one unloaded servo at most.
- Power it from a separate 5–6 V source with a common ground: under load the current reaches hundreds of mA, and at stall more than the SG90.
Revisions and clones
- MG90S clones with plastic gears inside exist: a metal shaft does not mean a metal gearbox.
All pins
| Label | Number | Functions | Limits | Check |
|---|---|---|---|---|
| GND | Ground | not from manufacturerTowerPro documents for the MG90S do not name the wire colors: taken from the SG90 of the same series (sellers agree).Brown wire.Labelled on other revisions as: brown | ||
| VCC | 5 V | power input | not from manufacturerTowerPro documents for the MG90S do not name the wire colors: taken from the SG90 of the same series (sellers agree).Red wire, in the middle of the connector.Labelled on other revisions as: red | |
| PWM | 50 Hz PWM: 1–2 ms (1.5 ms is the middle) | not from manufacturerTowerPro documents for the MG90S do not name the wire colors: taken from the SG90 of the same series (sellers agree).Orange wire. The servo usually accepts the 3.3 V signal from an ESP32 and Pico.Labelled on other revisions as: orange, S, signal |
Sources
Not verified against the manufacturer: 3 of 3 pins. The pin card says what confirms each one and where sources disagree.
- TowerPro: MG90Suser guide, checked 17.10.202613.4 g, 22.8×12.2×28.5 mm, ears 32.5, 1.8 kg·cm at 4.8 V, 2.2 at 6.6 V, JR connector
- TowerPro MG90S datasheet (Electronicos Caldas copy)datasheet, checked 17.10.2026supply 4.8–6.0 V, 0.1 s/60° at 4.8 V, size 22.5×12×35.5 (with shaft)
- TowerPro SG90 datasheet (same connector and wire colors)datasheet, checked 17.10.2026colors: brown GND, red +, orange PWM; period 20 ms, 1–2 ms
Size: 22.8×12.2 mm case, 32.5 across the ears (TowerPro); wires and connector are drawn schematically (approximate).
FAQ
- What supply voltage does the MG90S servo need?
- VCC (red): 4.8-6 V. 5 V logic.



