SG90 servo pinout

SG90 servo (TowerPro, 9 g), PWM-controlled servo, 5 V logic, 46×12.6 mm, 3 pins

verified15.10.2026

Important

  • Supply 4.8–6 V, signal logic 5 V (3.3 V is usually understood too).
  • Signal: period 20 ms (50 Hz), pulse 1–2 ms, center 1.5 ms.
  • TowerPro dimensions disagree in two places: 22.2×11.8×31 (drawing) and 23×12.2×29 (website).
  • The wires and connector in the picture are schematic: in the builder, wires are connected to the connector pins.
  • Power it from a separate 5 V source with a common ground, not from the Arduino 5V pin: at startup and under load the current reaches hundreds of mA.

Revisions and clones

  • MG90S: metal gears, same wires and connector (separate mg90s pinout).
  • On clones the wire colors can be black/red/white (GND/+/signal).

All pins

LabelNumberFunctionsLimitsCheck
GNDGroundverified
VCC5 Vpower inputverified
PWM50 Hz PWM: 1–2 ms (1.5 ms is the center), extended 0.5–2.4 msverified

Sources

Every pin is verified against the manufacturer's documents.

  • TowerPro SG90 datasheet (copy)datasheet, checked 15.10.2026dimensions 22.2/32.2/11.8/31 mm, wire colors (brown GND, red +, orange PWM), period 20 ms, 500–2400 µs, 4.8–6 V
  • TowerPro: SG90user guide, checked 15.10.2026JR connector, 4.8 V, size 23×12.2×29 mm, wire 25 cm
  • Pololu: servo cable / JR connectorthird-party source, checked 15.10.2026JR connector 0.1 inch pitch, plus in the middle

Size: body 22.2×11.8 mm, 32.2 mm across the ears (TowerPro drawing); the connector and wires are drawn schematically (approximate).

FAQ

What supply voltage does the SG90 servo need?
VCC (red): 4.8-6 V. 5 V logic.

You might also need

Similar boards