5 V 4 A power supply pinout
5 V 4 A power supply (5.5×2.1 plug, adapter to screw terminals), Mean Well GST25E05-P1J, 5 V logic, 36×22 mm, 2 pins
partly verified20.10.2026
Adapter on the left, cable to the terminal adapter on the right: + at the top, − at the bottom.
BuyDownload PNG- Chip
- Mean Well GST25E05-P1J
- Logic
- 5 V
- Power
- 220 V mains
Important
- Positive at the plug center (all Mean Well P1J are like this). For no-brand adapters, check with a multimeter before connecting the strip.
- Connect the supply negative to the microcontroller GND: without a common ground the data signal does not work.
- Current margin: count 60 mA per LED at full white. The strip power supply calculator on the site works out meters, current and wire.
- Wires from the terminals to the strip: for 4 A use at least 0.5 mm² on a short run, and on a long strip feed power from both ends.
- 5 V output up to 4 A (20 W). 4 A is enough for about 66 LEDs of a WS2812B strip at full white (60 mA each), or more at lower brightness.
Revisions and clones
- Open-frame supplies in a metal case (Mean Well LRS-35-5 at 7 A and similar): output on screw terminals V+ and V−, 220 V input on L and N.
All pins
| Label | Number | Functions | Limits | Check |
|---|---|---|---|---|
| + | 5 V | power output | not from manufacturerPlug polarity per Mean Well (positive at the center), no-name adapters may differ: check with a multimeter. The + and − labels on the adapter are placed differently by different sellers, check yours.Positive: center contact of the 5.5×2.1 plug (Mean Well, P1J connector).Labelled on other revisions as: V+, +5V, DC+ | |
| − | Ground | not from manufacturerPlug polarity per Mean Well (positive at the center), no-name adapters may differ: check with a multimeter. The + and − labels on the adapter are placed differently by different sellers, check yours.Negative: outer contact of the plug. Connect to the microcontroller GND (common ground).Labelled on other revisions as: -, V-, GND, DC- |
Sources
Not verified against the manufacturer: 2 of 2 pins. The pin card says what confirms each one and where sources disagree.
- Mean Well GST25E series specification (GST25E-SPEC 2026-04-03)datasheet, checked 20.10.2026GST25E05-P1J: 5 V, 4.0 A, 20 W, ripple up to 80 mV, accuracy ±5 %, input 85-264 V AC, efficiency 81.5 %; P1J plug 5.5×2.1×11 mm, center contact "+"
Size: schematic drawing: adapter, cable and a 5.5×2.1 female adapter to screw terminals (approximate).
You might also need
Similar boards

Adafruit Micro-Lipo USB-C LiPo charger (MCP73831, product 4410)
MCP73831T-2ACI/OT7 pins

BMS 1S protection board (3.7 V, DW01 + 8205A)
DW01A + FS8205A4 pins

BMS 2S protection board (7.4 V, with balancing)
2S protection controller (HY2120/HY2213 and equivalents) + MOSFET5 pins

BMS 3S protection board (11.1 V, with balancing)
3S protection controller (HY2120/HY2213 and equivalents) + MOSFET6 pins