TM1637 4-digit display pinout
TM1637 4-digit display (CLK, DIO, VCC, GND), Titan Micro TM1637, 5 V logic, 42×24 mm, 4 pins
partly verified17.10.2026
Front view, header on the right.
Download PNG- Chip
- Titan Micro TM1637
- Logic
- 5 V
- Power
- VCC 3.3-5.5 V
Important
- Not I2C: CLK and DIO to any GPIOs, library TM1637Display (Avishay Orpaz).
- It works from 3.3 V but is dimmer; on an ESP32 it can be powered from 5 V: DIO has a pull-up to the module VCC, on some boards that puts 5 V on the ESP32 pin, so power it from 3.3 V.
All pins
| Label | Number | Functions | Limits | Check |
|---|---|---|---|---|
| CLK | Clock (TM1637 two-wire interface) | not from manufacturerPin order from the module sellers' descriptions; the header position is not dimensioned.Any GPIO. Not I2C: it does not have to be connected to the SDA/SCL pins. | ||
| DIO | Data, open drain with a pull-up on the module | not from manufacturerPin order from the module sellers' descriptions; the header position is not dimensioned.Any GPIO. | ||
| VCC | 5 V | power input | not from manufacturerPin order from the module sellers' descriptions; the header position is not dimensioned. | |
| GND | Ground | not from manufacturerPin order from the module sellers' descriptions; the header position is not dimensioned. |
Sources
Not verified against the manufacturer: 4 of 4 pins. The pin card says what confirms each one and where sources disagree.
- Titan Micro TM1637 datasheet (English version, Makerguides copy)datasheet, checked 17.10.2026two-wire interface CLK, DIO (not I2C), 5 V supply, 8 brightness levels
- Makerguides: TM1637 4-digit 7-segment display with Arduinothird-party source, checked 17.10.2026module pins CLK, DIO, VCC, GND; supply 3.3–5 V
Size: about 42×24 mm, 0.36″ display; header position from a photo (approximate).
FAQ
- What supply voltage does the TM1637 4-digit display need?
- VCC: 3.3-5.5 V. 5 V logic.



